Monday, 24 July 2017

Circuit Monday #13 push button switch

Good afternoon folks and welcome to another Circuit Monday todays circuit is Push button switch 

Components needed 

one push button switch 
one led
one resistor 

all my Circuits are breadboarded on the prototype board I made here 





Uses for this circuit 

this is a simple push button switch that lets power flow as long as you hold the button down so it could be used as a basic dead switch 


Step one 

place the button into the board 

Step two

connect pin one of the switch to the positive rail of the board 

Step three

connect the resistor to pin 3 of the switch 

Step four

connect the anode of led to the resisitor then connect the cathode to the negative rail of the board 


Step five

time to test the circuit 


Firtzing Layout 






Don't forget to check out the daily dobby on social media Facebook   Twitter 


Thanks for taking the time to read this if you liked what you've read then please check back tomorrow after 17.00bst for another update thanks again. Dobby /

No comments:

Post a Comment

dobby repairs

Hi everyone I know that I haven't posted on here for quite some time  I probably won't be posting on here again for a while but I wa...

Total Pageviews