Project Day #10 LED Roulette kit

Good afternoon folks and welcome to another Project day this weeks project is the LED  Roulette kit

Why I made this project 

I made this for a bit of fun as most of my long term projects are not at the stage where I can post them yet so I hope you enjoy this 

Parts Needed

the parts needed for this project can be gotten from ebay very cheap 

Step one 

the first step is to place the resistors and the 103 capacitors into the pcb and solder them into place 

Step two

the next step is to place the switch and the two I C chips into the pcb and solder them into place 

Step three

the third step is place all the red leds into the pcb and solder them into place 

Step four

the fourth setup is to place the transistor and electrolytic capacitors into the pcb and solder them into place 

Step five

the next step is to solder some pins for connecting the power supply  

Step six

Now it's time to test the board there will be a video of this build put up later on today  with a video show it in action keep an eye on the facebook and twitter accounts  to see when its up 

Project video

                                    

Don't forget to check out the daily dobby on social media Facebook   Twitter 

Thanks for taking the time to read this if you liked what you've read then please check back tomorrow after 17.00bst for another update thanks again. Dobby